menuMENU    UK Free TV logo Help!

 

 

Click to see updates

Can I use a Freeview box if there is no SCART connector on my TV?

Can I use a Freeview box if there is no SCART connector on my TV?

Can I use a Freeview box if there is no SCART connector on my T
published on UK Free TV

Very few of the current Freeview boxes have both SCART and UHF outputs, but you will have to check.

This is done mainly to keep the costs down, but it saves any possible interference from the box itself with the incoming Freeview signals.

So with the a few boxes - often PVRs - you can watch (and record) Freeview channels via a UHF channel.

However, the best possible picture quality is obtained using the "RGB" output on the SCART connector, so if you switch the box to a new TV at some point, you should use the SCART then.



All questions
BBC Three Linear channel re-opens1
Removing all barriers to communication between diverse cultures2
How do I get a test card with Freeview3
What can I do when my Sky Digibox says 'No Signal' or 'Technical fau4
Can I receive UK TV in Ghana?5
In this section
Are all Widescreen TVs digital?1
If you have several TVs at home do you need separate decoders for each set or is2
What connections are used from set top box to TV (such as SCART) ?3
My video doesn't work with my digital TV box, help!4
My TV is NICAM, does that mean I have digital TV?5
Why has my widescreen TV just made everyone look fat?6

Comments
Saturday, 7 April 2012
M
maggie reavill
11:28 PM

hi dave and jb
thanks very much for all your help. it is an analogue vcr so will do as you suggest and invest in new pvr.
thanks very much.

link to this comment
maggie reavill's 2 posts GB flag
J
jb38
sentiment_very_satisfiedPlatinum

11:55 PM

maggie reavill: Yes, as these old VCR's as well as being very limited in what they can do are quite difficult for some people to set up for recording, unlike the device I provided the link for which is one of the easiest of all PVR's.

Should you purchase this particular model, if any further advice is required do not hesitate to ask.

link to this comment
jb38's 7,179 posts GB flag
Wednesday, 10 October 2012
A
ANDY
2:50 PM

hi how can i get my freeview box to work my 42" MONTIOR DONT HAVE SCART SOCKET THANKS ANDY

link to this comment
ANDY's 1 post GB flag
J
jb38
sentiment_very_satisfiedPlatinum

11:33 PM

ANDY: It would be of somewhat assistance to know what type (brand / model) of monitor you are referring to as well as the name of any connections you might see on the rear of the unit.

link to this comment
jb38's 7,179 posts GB flag
Wednesday, 19 December 2012
G
george
10:34 AM

hi i have samsung led tv UE50ES6100 model .unfortunately with only 1 scart connection available...i have 2 satellites with scart connections what do you advise me to do in order to watch both of satellites whenever i wish to do so
tx

link to this comment
george's 1 post CY flag
Saturday, 22 December 2012
D
Derek Smith
11:34 PM
Ebbw Vale

Hi,please could you help in getting my Samsung dvd hr725 (Which has an analogue tuner) to work with my t.v. and set top box.
Set top box is a Philips dtr 210-05--2 scart sockets and the t.v. is an Akura Portable, with inbuit Freeview, operated via a 240/12 volt power supply.
I DID get the tv,set top box to record onto a jvc vcr recorder, by moving the rf2 on the vcr, but I am unable to find any thing in my manual for doing this on the Samsung, although there is a passage in the manual re. connecting a set top box via the connectors on the front of the Samsung,
BUT this did not work anyway!
So, if possible, could you advise whether the Samsung CAN work & record with a Freeview set top box? And if so--HOW?!
I would be very gratefull.
Thanks for your time.
yours Derek

link to this comment
Derek Smith's 1 post GB flag
Derek's: mapD's Freeview map terrainD's terrain plot wavesD's frequency data D's Freeview Detailed Coverage
Sunday, 23 December 2012
Dave Lindsay
sentiment_very_satisfiedPlatinum

12:17 AM

Derek Smith: I think that you should feed your aerial in to your Philips receiver and then out and into your Akura TV (with in-built Freeview). There is no need to loop through the Samsung DVD because there are scart connections available.

I found the user manual for the Samsung here:

Support for DVD-HR725

The user manual for the Philips is here:

DTR210/05 Digital Terrestrial Receiver - Philips Support

(The information found at those links may be useful to anyone helping on here.)


I think that you should connect a scart lead between the TV socket on the Philips and AV2 of the Samsung. Then connect another scart lead from AV1 of the Samsung and the TV.

The reason I say to use the TV output socket of the Philips is because it supports RGB and the VCR/DVD one does not.

With RGB the picture is sent along the scart cable using three wires (one for each of the colours - red, green and blue). If RGB isn't available, then you would probably use composite video (CVBS). This uses one wire to carry the picture and so because everything has to be combined down a single conductor and split up again at the other end, the picture isn't as good.

On the Philips go to the Configuration menu and set TV Out to "RGB".


If the TV supports RGB, then set the Samsung to output RGB, else leave it on CVBS (Component). This can be changed via the menu > Setup > Video > Video Output.

link to this comment
Dave Lindsay's 5,724 posts GB flag
Dave Lindsay
sentiment_very_satisfiedPlatinum

10:26 AM

Derek Smith: In last paragraph, I said "CVBS (Component)". These are in fact two different systems, but the Samsung allows two "Video Output" settings: Component and RGB

If RGB isn't supported, then leave it on Component. The point being to use RGB if it is supported.

link to this comment
Dave Lindsay's 5,724 posts GB flag
Monday, 21 October 2013
A
Alan Last
10:46 AM

How can I set up a portable t v with no scart scocket only the old type aerial input.

link to this comment
Alan Last's 1 post GB flag
M
MikeB
sentiment_very_satisfiedPlatinum

11:24 AM

Alan Last: if your connecting it to a freeview box, the boxes instructions should tell you how to do it - most have rf in/rf out for just this problem. You should put the aerial lead from the wall socket to the rf in socket on the back of the box, and then another aerial lead from the second (out) socket to the normal aerial socket on the back of the tv.

This does sound like a very old TV, and I would be wary of spending too much money on making it digital-£20 is reasonable, but since a brand new wfi smart Samsung 22 is only £219, you pays your money.....

link to this comment
MikeB's 2,579 posts GB flag
Select more comments

Your comment please
Please post a question, answer or commentUK Free TV is here to help people. If you are rude or disrespectful all of your posts will be deleted and you will be banned.







Privacy policy: UK Free Privacy policy.