Full Freeview on the Oxford (Oxfordshire, England) transmitter
Google Streetview | Google map | Bing map | Google Earth | 51.790,-1.179 or 51°47'25"N 1°10'46"W | OX3 9SS |
The symbol shows the location of the Oxford (Oxfordshire, England) transmitter which serves 410,000 homes. The bright green areas shown where the signal from this transmitter is strong, dark green areas are poorer signals. Those parts shown in yellow may have interference on the same frequency from other masts.
_______
Digital television services are broadcast on a multiplexes (or Mux) where many stations occupy a single broadcast frequency, as shown below.
64QAM 8K 3/4 27.1Mb/s DVB-T MPEG2
DTG-12 QSPK 8K 3/4 8.0Mb/s DVB-T MPEG2
H/V: aerial position (horizontal or vertical)
Which Freeview channels does the Oxford transmitter broadcast?
If you have any kind of Freeview fault, follow this Freeview reset procedure first.Digital television services are broadcast on a multiplexes (or Mux) where many stations occupy a single broadcast frequency, as shown below.
64QAM 8K 3/4 27.1Mb/s DVB-T MPEG2
DTG-12 QSPK 8K 3/4 8.0Mb/s DVB-T MPEG2
H/V: aerial position (horizontal or vertical)
Which BBC and ITV regional news can I watch from the Oxford transmitter?

BBC South (Oxford) Today 0.4m homes 1.6%
from Oxford OX2 7DW, 6km west-southwest (258°)
to BBC South (Oxford) region - 6 masts.
BBC South (Oxford) Today shares 50% content with Southampton service

ITV Meridian News 0.9m homes 3.4%
from Whiteley PO15 7AD, 102km south (182°)
to ITV Meridian/Central (Thames Valley) region - 15 masts.
Thames Valley opt-out from Meridian (South). All of lunch, weekend and 50% evening news is shared with all of Meridian+Oxford
How will the Oxford (Oxfordshire, England) transmission frequencies change over time?
1950s-80s | 1984-97 | 1997-98 | 1998-2011 | 2011-13 | 2013-18 | 2013-17 | 23 May 2018 | ||
VHF | C/D E | C/D E | C/D E | C/D E | C/D E T | W T | W T | ||
C2 | BBCtvwaves | ||||||||
C29 | SDN | ||||||||
C31 | com7 | com7 | |||||||
C37 | com8 | com8 | |||||||
C41 | BBCA | ||||||||
C44 | D3+4 | ||||||||
C46 | _local | ||||||||
C47 | BBCB | ||||||||
C49tv_off | C5waves | C5waves | |||||||
C50tv_off | SDN | SDN | |||||||
C51tv_off | LOX | LOX | |||||||
C53tv_off | C4waves | C4waves | C4waves | +BBCA | +BBCA | +BBCA | |||
C55tv_off | ArqB | ArqB | ArqB | com7tv_off | |||||
C56tv_off | COM8tv_off | ||||||||
C57tv_off | BBC1waves | BBC1waves | BBC1waves | BBCB | BBCB | BBCB | |||
C59tv_off | -ArqA | -ArqA | -ArqA | ||||||
C60tv_off | ITVwaves | ITVwaves | ITVwaves | -D3+4 | -D3+4 | -D3+4 | |||
C62 | SDN | ||||||||
C63 | BBC2waves | BBC2waves | BBC2waves |
tv_off Being removed from Freeview (for 5G use) after November 2020 / June 2022 - more
Table shows multiplexes names see this article;
green background for transmission frequencies
Notes: + and - denote 166kHz offset; aerial group are shown as A B C/D E K W T
waves denotes analogue; digital switchover was 14 Sep 11 and 28 Sep 11.
How do the old analogue and currrent digital signal levels compare?
Analogue 1-4 | 500kW | |
BBCA, D3+4, BBCB | (-7dB) 100kW | |
SDN, ARQA, ARQB | (-10dB) 50kW | |
Analogue 5 | (-11dB) 40kW | |
com8 | (-14.7dB) 17.1kW | |
com7 | (-14.8dB) 16.4kW | |
Mux 1*, Mux 2*, LOX | (-17dB) 10kW | |
Mux C*, Mux D* | (-18dB) 8kW | |
Mux A*, Mux B* | (-19.2dB) 6kW |
Which companies have run the Channel 3 services in the Oxford transmitter area
|
|
Sunday, 19 January 2014
R
rob8:56 AM
Kidlington
Hi again,
will try the neighbors first, but could be tetra then as the interference only affects the channels 60 programmes then?
lets hope its the neighbors!
thanks again
Rob
link to this comment |
rob's: mapR's Freeview map terrainR's terrain plot wavesR's frequency data R's Freeview Detailed Coverage
P
pikpilot12:57 PM
As moving the tv or changing lead length makes so much difference and as you are relatively close to the transmitter, don't rule out the possibility that there is a break in the coax lead from the aerial to the set. The signal you are getting may be just the coax acting as the aerial, thus giving differences in signal strength as you change coax length and position. A break will also give you different effects on each frequency as it will not be a 75 Ohm match
It is very easy to test with a multimeter. At the aerial end, join the inner and outer of the coax and then at the set end use a multimeter (or even a battery and torch bulb) to check for continuity between the inner and outer of the coax.
I have seen this before and the lack of a shield on the wire (in effect) also produces resonance at strange frequencies. Check continuity also at your spurs to other sets as a break in their coax will act as another input on a different (interfering) frequency.
link to this comment |
R
rob1:17 PM
Kidlington
If it was a break in the coax would i not be getting the interference on all the channels? I am only experiencing issues off channel 60 mux. No other channels are an issue not one.
really find this frequency stuff confusing, thanks for all the help.
Rob
link to this comment |
rob's: mapR's Freeview map terrainR's terrain plot wavesR's frequency data R's Freeview Detailed Coverage
N
nickwilcock7:58 PM
Were any taxis operating in the vicinity? Or police vehicles? Both used to upset my TV reception if they used their radios nearby.
link to this comment |
R
rob8:30 PM
Kidlington
I live near Thames valley headquarters in kidlington and near the police station too. However never been an issue before and lived here 12 years now.
regards
Rob.
link to this comment |
rob's: mapR's Freeview map terrainR's terrain plot wavesR's frequency data R's Freeview Detailed Coverage
P
pikpilot11:07 PM
A break in the coax means you have an unterminated length of wire that is resonant at a frequency that is set by its length and the velocity factor of the wire. This can enhance or nullify signals at one frequency. Worth a check as it is simple to do.
link to this comment |
Monday, 20 January 2014
OXFORD transmitter - Over the next week Oxford main transmitter: TV (digital) Liable to interruption, Radio (analogue) working normally, Radio (digital) working normally. [DUK]
link to this comment |
R
rob10:40 AM
Kidlington
Hi All,
Could this be the problem, strange how there are now works on the mast. Does anyone know the detail of the works, are they relating to channel 60 issues?
Regards
Rob
link to this comment |
rob's: mapR's Freeview map terrainR's terrain plot wavesR's frequency data R's Freeview Detailed Coverage
R
rob5:30 PM
Kidlington
Right, neighbors are yet to get back to me on anything the other side of the wall. I have borrowed a SLX dvb-t signal meter, lights up 80 top figure on the device, after the splitter 60 at socket down stairs. 50 at back of tv, still the same issue with everything on channel 60 having intermittent blocky picture and sound clipping, not all the time just hiccups at random times but can be every 20 seconds or wait 2-3 mins and starts again.
again thanks for the help all.
Rob
link to this comment |
rob's: mapR's Freeview map terrainR's terrain plot wavesR's frequency data R's Freeview Detailed Coverage
R
rob10:16 PM
Kidlington
Well hi all again, my neighbors still have not got back to me so tried a borrowed set top box and placed it on top of my hard drive recorder and not a blip all night, could this still mean its interference on the Sony tv or is the tuner on the blink?
again any advice would be appreciated.
Regards
Rob
link to this comment |
rob's: mapR's Freeview map terrainR's terrain plot wavesR's frequency data R's Freeview Detailed Coverage
Select more comments
Your comment please