Full Freeview on the Rowridge (Isle Of Wight, England) transmitter
Google Streetview | Google map | Bing map | Google Earth | 50.676,-1.369 or 50°40'35"N 1°22'7"W | PO30 4HT |
The symbol shows the location of the Rowridge (Isle Of Wight, England) transmitter which serves 620,000 homes. The bright green areas shown where the signal from this transmitter is strong, dark green areas are poorer signals. Those parts shown in yellow may have interference on the same frequency from other masts.
_______
Digital television services are broadcast on a multiplexes (or Mux) where many stations occupy a single broadcast frequency, as shown below.
64QAM 8K 3/4 27.1Mb/s DVB-T MPEG2
DTG-12 QSPK 8K 3/4 8.0Mb/s DVB-T MPEG2
H/V: aerial position (horizontal or vertical)
Which Freeview channels does the Rowridge transmitter broadcast?
If you have any kind of Freeview fault, follow this Freeview reset procedure first.Digital television services are broadcast on a multiplexes (or Mux) where many stations occupy a single broadcast frequency, as shown below.
64QAM 8K 3/4 27.1Mb/s DVB-T MPEG2
DTG-12 QSPK 8K 3/4 8.0Mb/s DVB-T MPEG2
H/V: aerial position (horizontal or vertical)
Which BBC and ITV regional news can I watch from the Rowridge transmitter?

BBC South Today 1.3m homes 4.9%
from Southampton SO14 7PU, 26km north (354°)
to BBC South region - 39 masts.

ITV Meridian News 0.9m homes 3.6%
from Whiteley PO15 7AD, 24km north-northeast (20°)
to ITV Meridian (South Coast) region - 39 masts.
All of lunch, weekend and 50% evening news is shared with all of Meridian plus Oxford
Are there any self-help relays?
Portsmouth Docks | Transposer | 2 km N city centre | 50 homes Estimate. Group of houses' |
How will the Rowridge (Isle Of Wight, England) transmission frequencies change over time?
1950s-80s | 1984-97 | 1997-98 | 1998-2012 | 2012-13 | 2 May 2018 | ||||
VHF | A K T | A K T | A K T | A K T | W T | ||||
C3 | BBCtvwaves | ||||||||
C21 | C4waves | C4waves | C4waves | +BBCB | BBCB | ||||
C22 | +ArqA | ArqA | |||||||
C24 | BBC2waves | BBC2waves | BBC2waves | BBCA | BBCA | ||||
C25 | SDN | SDN | |||||||
C27 | ITVwaves | ITVwaves | ITVwaves | D3+4 | D3+4 | ||||
C28 | ArqB | ArqB | |||||||
C29 | LSO | ||||||||
C31 | BBC1waves | BBC1waves | BBC1waves | com7 | |||||
C37 | com8 | ||||||||
C55tv_off | com7tv_off | ||||||||
C56tv_off | COM8tv_off |
tv_off Being removed from Freeview (for 5G use) after November 2020 / June 2022 - more
Table shows multiplexes names see this article;
green background for transmission frequencies
Notes: + and - denote 166kHz offset; aerial group are shown as A B C/D E K W T
waves denotes analogue; digital switchover was 7 Mar 12 and 21 Mar 12.
How do the old analogue and currrent digital signal levels compare?
Analogue 1-4 | 500kW | |
PSB1||, PSB1≡, PSB2||, PSB2≡, PSB3||, PSB3≡ | (-4dB) 200kW | |
COM4≡, COM4||, COM5≡, COM5||, COM6≡, COM6|| | (-10dB) 50kW | |
com7≡ | (-13.1dB) 24.4kW | |
Mux 1*, Mux 2*, Mux A*, Mux B*, Mux C*, Mux D* | (-14dB) 20kW | |
com8≡ | (-14.3dB) 18.4kW | |
LSO≡ | (-17dB) 10kW |
Local transmitter maps
Rowridge Freeview Rowridge DAB Rowridge TV region BBC South Meridian (South Coast micro region)Which companies have run the Channel 3 services in the Rowridge transmitter area
|
|
Friday, 21 December 2012
A
adrian_tcp11:56 PM
Fordingbridge
Also, when you say vertical aerial polarisation, do you simply mean that you turn the aerial through 90 degrees so that the aerial prongs point up and down? This would also mean that all other parts of the aerial assembly would be turned through 90.
link to this comment |
adrian_tcp's: mapA's Freeview map terrainA's terrain plot wavesA's frequency data A's Freeview Detailed Coverage
Saturday, 22 December 2012
K
KMJ,Derby9:59 AM
adrian_tcp: Yes, the prongs (directors), the dipole (where the coax is connected) and the reflector (the plate or set of rods at the back end) are all vertical. The boom of the aerial should be horizontal or have a very slight tilt up towards the transmitter.
link to this comment |
J
jb3810:18 AM
adrian_tcp: As far as the aerial mounting is concerned its a case of the entire aerial being in effect being turned on its side, because the vertically polarised COM signals from Rowridge radiate on 200Kw whereas on horizontal its only 50Kw, however the fact of you having said that you suffer from pixilation on the PSB2 & PSB3 muxes does not give much hope as far as glitch free reception is concerned, but though it depends on what you observe on a signal quality check, because if both the strength and quality are seen to fluctuate within a certain range but never at any time rapidly dip to near zero and back again, then keeping the signal running at a high level can in many cases help to keep pixilation to a minimum, but if the quality is seen to frequently dive to zero and back then no matter how fast it does it the picture will suffer.
The problem is, that when that sort of thing occurs there is virtually nothing that can be done at the receiving end that will help the situation as the problem is outwith local control, as its basically caused by the signal path from the transmitter to the receiver being affected by obstructions along the way, and with the most commonly experienced reason being trees and such likes even if they have shed their leaves, and with quick check over the signal path between Rowridge and your area indicating quite a number of hazardous areas for RF signals.
However, I suggest that you carry out the check referred to, that is on the assumption that your TV or box does offer both a strength and quality indicator and giving an update on the results of the check.
By the way if the brown coax referred to is of the thinner variety then it should be changed to a satellite grade such as WF100, but if its the thicker variety with a woven copper mesh that does not separate easily then its most likely perfectly OK.
link to this comment |
Sunday, 23 December 2012
A
adrian_tcp3:10 PM
Fordingbridge
Thanks. I only have strength, not quality. However, on Film4 which is one of the worst, signal strength is 68-72 but Bit error level is max at 2000, whatever that means. ITV2+1 is 58-62 but no but errors and not pixilated, so is there anyway of reducing the bit errors, like having 2 amplifiers in series?
link to this comment |
adrian_tcp's: mapA's Freeview map terrainA's terrain plot wavesA's frequency data A's Freeview Detailed Coverage
Monday, 31 December 2012
F
Frederick love9:51 AM
My XP media centre PC tuned to Rowridge can only get the program guide up to the end of this year.
In spite of retuning and reloading all stations the program guide loads no data for 2013 and therefore now has no search facility.
link to this comment |
Frederick love: Well... one option is to take the cheap Windows 8 upgrade
Buy Windows - Microsoft Windows
(£24.99) and then
Add features - Microsoft Windows
(free) - I will cost you and a couple of hours.
link to this comment |
M
Michael8:44 PM
Briantist: It's a problem with my Vista media centre EPG as well, seems a lot of people are reporting the problem on the internet - I doubt buying Win8 will solve the issue.
link to this comment |
Tuesday, 1 January 2013
Michael: Doubt if you like but here is my Whitehawk Hill and Rowridge listings in Win 7 right now...

link to this comment |
M
Michael12:10 PM
Briantist: Win7 should be ok for a 7 day EPG as that uses broadcast data, unlike XP and Vista.
Found a thread on it, and it's also been reported to Microsoft: View topic - Guide Updates - Download Issues
Resorting to trying EPG Collector to see what happens (instructions at the end of that thread).
link to this comment |
Michael: The Win7 (and Vista if you have installed the upgrades - Freeview news | ukfree.tv - 10 years of independent, free digital TV advice ) Media Center can use either the internet-delivered (from DigiGuide) or Freeview-delievered listings.
From the "TV Programme Guide" screen, right click on a channel (like "1 BBC One") and choose "Edit channel". You then see...

And select "use listings from broadcaster".
link to this comment |
Select more comments
Your comment please