All posts by ian a
Below are all of ian a's postings, with the most recent are at the bottom of the page.R- Maybe first call could be a local or national installer to ask if there are any reported problems, also neighbours to see if its the same with them ?
If the problem isn't at the BBC end then the problem may well be at your end ?
| link to this comment |
I
Nottingham (Nottinghamshire, England) Full Freeview transmitterWednesday 29 May 2013 8:59PM
Nottingham
Charlotte - Just to add to jb38's advice, If you want to know if there is a problem in your flat, A simple signal test at the wall plate will tell you.
Any aerial engineer will be able to do this for a small call out charge, prob take about 15 mins
| link to this comment |
I
Sutton Coldfield (Birmingham, England) Full Freeview transmitteWednesday 29 May 2013 9:15PM
Nottingham
Dave Lindsey/Peter Hedges- On the EPG recrding problem ? If recording BBC1 and choosing ch800 surely the recorder will follow the Oxford transmitter EPG as this will be the one shown on the guide?
just a side thought?
| link to this comment |
Mike- are you watching freeview thru a built in tv or a freeview box? if its a freeview box, how is it connected to the tv? are there any other tv's in the house connected to the aerial?
| link to this comment |
Antony Portno, KMJ,Derby- Antony did the device ask you to select region after re-tuning? if so check BBC2 and BBC1 have the same frequency?
KMJ,Derby i have noticed some freeview boxes after asking for a region then only alter BBC1 and ITV but store the others on the first come first stored basis, only the odd box tho?
| link to this comment |
NigelVain-have your tried a factory reset? after that i would try a freeview box on the aerial cable to rule out the tv as the problem
| link to this comment |
MICK SYKES- Are there any stations stored in the ch800 or above ?
Also have you done a factory reset, Then a retune without the aerial attached ?
| link to this comment |
Savid Waterhouse- i know you said you are recieving from emley moor, but with relays being around the tuning may still state so even if your tv's are picking up the relay signals,
double check the frequency numbers with the ones Dave Lindsey has provided
| link to this comment |
David Waterhouse- Just for elimination process, can you remove the amp from 1 of the sets and re-check the signal figures ?
| link to this comment |
Sunday 19 May 2013 8:26AM
Nottingham
Omhie,jb38- yes mate, only put the feed as its not stated which it is?
twin feed boxes are easier to get hold of tho?