menuMENU    UK Free TV logo Archive (2002-)

 

 

Click to see updates

Final switchover for The Wrekin, Ridge Hill groups on 20th April in 2011 week 4

If you are in the west of Central England, you will use the The Wrekin, Ridge Hill, Lark Stoke, Bromsgrove transmitters, or one of the many relay transmitters.

If you are in the west of Central England, you will use the The
published on UK Free TV

Viewers in Shewsbury, Telford, Bridgenorth, Wolverhampton, Ludlow, Hereford, Ross-on-Wye, Gloucester, Cheltenham and Bromsgrove will have no analogue television from Wednesday 20th April 2011. Unless you use cable or satellite to watch television, if you don't use a Freeview box or set, your screen will be blank.

Most people need only retune their Freeview box or TV, but it would be impossible with 634,600 homes covered by the transmitters, that there would be no problems.



From Wednesday 20th April 2011 you MUST have a digital television device to watch TV. If you do not have a digital receiver, from Wednesday will have a blank screen.



Do not expect a terrestrial television service from midnight until 6am - or a late as lunchtime on relay transmitters.

If you are over 75, get (or could get) Disability Living Allowance, Attendance Allowance, Constant Attendance Allowance or mobility supplement; or have lived in a care home for six months or more; or are registered blind or partially sighted and need assistance, please see The Switchover Help Scheme.

Central England picture

Cable and satellite

Cable (Virgin Media) and satellite (Sky, Freesat, fSfS) viewers are not affected by the changes. Remember, however, that you may be using analogue TV to watch on a second or third set and it might need a Freeview box.

Existing Freeview users

If you already use Freeview, and can receive all the channels now, check your TV or box is not listed here - TVs and boxes that do not support the 8k-mode. If it is, you will need a new box.

If you are not on the list, you should scan your box from around 6am.

When you now rescan, you MUST do a "first time installation" or "factory reset" scan, not an "add channels". Do the procedure you did on September 30th 2009. If you can't recall what this was, please see generic clear and rescan procedure.

If you scanned during the first phase of switchover on Wednesday 6th April 2011 - you will have to do it again on Wednesday 20th April 2011.

Restrictions on SDN, Arqiva A and Arqiva B multiplexes

Because the change to 64QAM mode on multiplex D/Arqiva B on Wednesday 20th April 2011, this will mean a small number of viewers will be unable to receive Arqiva B. This is to allow the provision of Sky Sports 1 and Sky Sports 2 to BT Vision customers.

After Wednesday 20th April 2011 at The Wrekin, the Arqiva multiplexes will remain on their pre-switchover frequencies and powers, and SDN will use a temporary frequency, for a short period before all three multiplexes adopt their final frequencies and powers during September 2011. During this transition period the commercial multiplexes will use the following frequencies: SDN C49 and C31 (both 2kW), Arqiva A C53 C57 (1kW), Arqiva B C57 C53 (1kW).

After Wednesday 20th April 2011 at Bromsgrove, Arqiva A will remain on its pre-switchover channel (33) until September 2011. Arqiva A and Arqiva B will temporarily operate on C34 and C29 respectively from the first stage of switchover at Bromsgrove until September 2011.

From Wednesday 20th April 2011 at Lark Stoke, Arqiva A and Arqiva B will remain on their existing frequencies and powers, and the SDN multiplex will use a temporary frequency. All three multiplexes will adopt their final frequencies and powers during September 2011. During this transition period following frequencies will be used: SDN C31 (50W), Arqiva A C57 (25/50W), Arqiva B C60 (25W).

HTV West service from Ridge Hill transmitter

From Wednesday 20th April 2011 there will be a second D3+4 multiplex on C29 to supply the ITV1 (ex HTV) West service, in addition to the ITV1 Central West.

Using Freeview with Windows Vista

Please see Switch over and PC-based systems because you need some updates for your system to work.

Boosters

If you live close to the transmitter, you may have to disconnect any "boosters" from your aerial system. The new, more powerful digital signals may overload any amplifiers and result in no reception! When looking for them include a check for distribution amplifiers, loft boxes, set back amplifiers, bypass Amplifiers, hidden masthead amps in a loft space and any dodgy active splitters.

Homes without Freeview

If you had no Freeview service before, you will have the BBC channels digitally from Wednesday 6th April 2011. This is a single multiplex of the BBC channels (radio, television and text) for most people.

However, if you were on the fringes of reception from one of the main Freeview transmitters, you will now get all the Freeview channels.

If you didn't get this limited Freeview service in November then you may need a new aerial.

If you are served by a public service (relay) transmitter If you use Andoversford, Bucknell, Churchdown Hill, Clun, Coalbrookdale, Eardiston, Ewyas Harold, Garth Hill VP, Haden Hill, Halesowen, Hazler Hill, Hereford, Hope under Dinmore, Kington, Knucklas, Ludlow, New Radnor, Oakeley Mynd, Peterchurch, Presteigne, Ross on Wye, St Briavels or Upper Soudley you now need, from lunchtime on December 2nd to rescan, and you will get a second Multiplex with ITV 1, ITV 2, ITV 1 +1, Channel 4, Channel 5, Channel 4+1, E4 and More4. And that's your lot, see Freeview retune - poor public service transmitters.

Everyone who has digital TV now has Freeview HD.

Digital regional overlap

The old analogue TV signals provided lots of nations and regions for the public service channels, and these have large areas of overlap.

The old low power digital TV signals were at very low levels and reception of signals from more than one transmitter was a rare event.

All Freeview boxes automatically scan the available broadcast frequencies looking for channels, and they do this from C21 to C69. Whilst scanning, if a duplicate version of a channel is found, such as another BBC One region, they are placed in the 800-899 channel range.

The 800-899 is easy to access by pressing CH- from 1, and in most programme guides is just a single scroll up.

Freeview HD

Freeview HD will start on Wednesday 20th April 2011 from the The Wrekin, Ridge Hill, Lark Stoke, Bromsgrove and all the relay transmitters. You will need a Freeview HD - DVB-T2 receiver to watch the channels. A HD TV set with Freeview is not enough.

Help with Freeview, aerials?
How do I get a test card with Freeview1
I would like to know if it is possible to receive UK terrestrial Freeview servic2
I have been told I would receive too much singal from my Freeview tansmitter as 3
Can my Freeview box receive more than one BBC and ITV region?4
Is it true that my 87 year old mother is entitled to a FREE upgrade when the ana5
In this section
Should the UK close down the TV networks to allow for more mobile broadband? 1
UK Digital switchover ends - Northern Ireland completes on 24th October 20122
The last day of analogue television in the UK - goodbye PAL3
2 days left of analogue television - goodbye teletext4
3 days of analogue to go - goodbye to NICAM 7285
Changes to Saorview frequencies and power levels, 24th October 20126

Comments
Thursday, 21 April 2011
S
Steve
sentiment_satisfiedGold

1:41 PM
Wrexham

Very odd. Just checked and I get it OK with the rooftop ae. Weak - but if you get one channel on a mux would expect all.

Try retuning? Or re Installing

link to this comment
Steve's 1,173 posts GB flag
Steve's: mapS's Freeview map terrainS's terrain plot wavesS's frequency data S's Freeview Detailed Coverage
P
Paul Durham
1:48 PM

Already tried that, will probably keep trying every now and then, give it a few days then try and find a helpline. Thanks anyway. Typical it's the one channel I want to watch.

link to this comment
Paul Durham's 4 posts GB flag
P
Paul Durham
2:31 PM

Ok the technicalities have me beaten but just done another scan and the channel there, signal strentgh has dropped but not too bad, Hey at least I can watch my cricket now. Thanks for your help guys.

link to this comment
Paul Durham's 4 posts GB flag
S
Steve
sentiment_satisfiedGold

4:36 PM
Wrexham

PD The probable technical explanation is that Channel 24 was occupied by another frequency and for whatever reason not replaced when you rescanned - but has been now.

link to this comment
Steve's 1,173 posts GB flag
Steve's: mapS's Freeview map terrainS's terrain plot wavesS's frequency data S's Freeview Detailed Coverage
Ian
sentiment_satisfiedGold

6:40 PM
Hinckley

Same thing happened to me on channel 31 from the Waltham transmitter, 24 hours later all was fine??????? very strange.

link to this comment
Ian's 497 posts GB flag
Ian's: mapI's Freeview map terrainI's terrain plot wavesI's frequency data I's Freeview Detailed Coverage
S
Steve
sentiment_satisfiedGold

7:40 PM
Wrexham

They are currently doing masses of switching around of equipment and settings, so I think a degree of disruption is inevitable.

link to this comment
Steve's 1,173 posts GB flag
Steve's: mapS's Freeview map terrainS's terrain plot wavesS's frequency data S's Freeview Detailed Coverage
Thursday, 12 May 2011
C
Claire
10:03 AM

Being honest - I am totally dense when it comes to this type of thing. So I am hoping for some simple advice really.

Location - Tewkesbury

I have a newish telly with built in freeview. We had the 1st switch off so telly was re-tuned then the 2nd within days so retuned again. All the freeview channels were there before and working fine. They are all there now but some seem to go all pixely while watching them. Why would this happen and how to I resolve it?

Please help!

link to this comment
Claire's 1 post GB flag
S
Steve
sentiment_satisfiedGold

4:10 PM

Claire - Plug your postcode in at top right of this page to check which transmitter you use - probably Ridge Hill Freeview on Ridge Hill TV transmitter | ukfree.tv - independent free digital TV advice others seem to have same problem if you ask there you may get local input.
Compare the weak channels with the listings to see which "Mux" is the problem (LL145HD)

link to this comment
Steve's 1,173 posts GB flag
Briantist
sentiment_very_satisfiedOwner

6:47 PM

Claire: First check your set is not on the TVs and boxes that do not support the 8k-mode | ukfree.tv - independent free digital TV advice list.

If it is not, if you have any boosters or amplifiers then disconnect them from your syste, you may have too much signal now.

link to this comment
Briantist's 38,915 posts GB flag
Select more comments
Page 4

Your comment please
Please post a question, answer or commentUK Free TV is here to help people. If you are rude or disrespectful all of your posts will be deleted and you will be banned.







Privacy policy: UK Free Privacy policy.