menuMENU    UK Free TV logo Archive (2002-)

 

 

Click to see updates

Final switchover for Sandy Heath and Nottingham on 13th April in 2011 week 3

If you are in the west of East Anglia, you will use the Sandy Heath transmitter, or one of the three relays at Luton, Kimpton, Dallington Park (Northampton). You may use the Nottingham transmitter if you are in the very central section of Nottingham.

If you are in the west of East Anglia, you will use the Sandy H
published on UK Free TV

Viewers in Cambridge, Bedford, Northampton, Stevenage, Ely, Milton Keynes and surrounding areas will have no analogue television from Wednesday 13th April 2011. Unless you use cable or satellite, if you don't have a Freeview box or set, your screen will be blank.

Most people need only retune their Freeview box or TV, but it would be impossible with 965,700 homes covered for there to be no problems. This also applies to the 74,000 homes that use the Nottingham transmitter.



From Wednesday 13th April 2011 you MUST have a digital television device to watch TV. If you do not have a digital receiver, from Wednesday will have a blank screen.

Do not expect a terrestrial television service from midnight until 6am - or a late as lunchtime on relay transmitters.

If you are over 75, get (or could get) Disability Living Allowance, Attendance Allowance, Constant Attendance Allowance or mobility supplement; or have lived in a care home for six months or more; or are registered blind or partially sighted and need assistance, please see The Switchover Help Scheme.



After 16,711 days (nearly 46 years), Sandy Heath will no longer broadcast analogue television signals.

Cable and satellite

Cable (Virgin Media) and satellite (Sky, Freesat, fSfS) viewers are not affected by the changes. Remember, however, that you may be using analogue TV to watch on a second or third set and it might need a Freeview box.

Existing Freeview users

If you already use Freeview, and can receive all the channels now, check your TV or box is not listed here - TVs and boxes that do not support the 8k-mode. If it is, you will need a new box.

If you are not on the list, you should scan your box from around 6am.

When you now rescan, you MUST do a "first time installation" or "factory reset" scan, not an "add channels". Do the procedure you did on September 30th 2009. If you can't recall what this was, please see List of manuals for Freeview retune, or try the generic clear and rescan procedure.

If you scanned during the first phase of switchover on Wednesday 30th March 2011 - you will have to do it again ON Wednesday 13th April 2011.

Using Freeview with Windows Vista

Please see Switch over and PC-based systems because you need some updates for your system to work.

Boosters

If you live close to the transmitter, you may have to disconnect any "boosters" from your aerial system. The new, more powerful digital signals may overload any amplifiers and result in no reception! When looking for them include a check for distribution amplifiers, loft boxes, set back amplifiers, bypass Amplifiers, hidden masthead amps in a loft space and any dodgy active splitters.

Homes without Freeview

If you had no Freeview service before, you will have the BBC channels digitally from Wednesday 30th March 2011. This is a single multiplex of the BBC channels (radio, television and text) for most people.

However, if you were on the fringes of reception from one of the main Freeview transmitters, you will now get all the Freeview channels.

If you didn't get this limited Freeview service in November then you may need a new aerial.

If you are served by a public service (relay) transmitter

You now need, from lunchtime on December 2nd to rescan, and you will get a second Multiplex with ITV 1, ITV 2, ITV 1 +1, Channel 4, Channel 5, Channel 4+1, E4 and More4. And that's your lot, see Freeview retune - poor public service transmitters .

Everyone who has digital TV now has Freeview HD.

Digital regional overlap

The old analogue TV signals provided lots of nations and regions for the public service channels, and these have large areas of overlap.

The old low power digital TV signals were at very low levels and reception of signals from more than one transmitter was a rare event.

All Freeview boxes automatically scan the available broadcast frequencies looking for channels, and they do this from C21 to C69. Whilst scanning, if a duplicate version of a channel is found, such as another BBC One region, they are placed in the 800-899 channel range.

The 800-899 is easy to access by pressing CH- from 1, and in most programme guides is just a single scroll up.

Freeview HD

Freeview HD will start on Wednesday 13th April 2011 from Sandy Heath and the relay transmitters. You will need a Freeview HD - DVB-T2 receiver to watch the channels. A HD TV set with Freeview is not enough.

Help with Freeview, aerials?
How do I get a test card with Freeview1
I would like to know if it is possible to receive UK terrestrial Freeview servic2
I have been told I would receive too much singal from my Freeview tansmitter as 3
Can my Freeview box receive more than one BBC and ITV region?4
Is it true that my 87 year old mother is entitled to a FREE upgrade when the ana5
In this section
Should the UK close down the TV networks to allow for more mobile broadband? 1
UK Digital switchover ends - Northern Ireland completes on 24th October 20122
The last day of analogue television in the UK - goodbye PAL3
2 days left of analogue television - goodbye teletext4
3 days of analogue to go - goodbye to NICAM 7285
Changes to Saorview frequencies and power levels, 24th October 20126

Comments
Thursday, 28 April 2011
C
chrism42
sentiment_satisfiedBronze

9:53 PM
Cambridge

I'm on the west side of cambridge; sandy heath transmitter is through a gap between the blocks of executive apartments over the road; aerial is in the loft with an amplifier. What I'd like to hear some opinions on is why the ITV PSB2 mux (C24) is rock-solid with a constant zero bit error rate and 2dB better than the BBC PSB1 mux (C27) which, while registering 100% signal quality, definitely is showing some bit errors, unless they are still fiddling with signal strength and direction at the transmitter?

link to this comment
chrism42's 29 posts GB flag
chrism42's: mapC's Freeview map terrainC's terrain plot wavesC's frequency data C's Freeview Detailed Coverage
C
chrism42
sentiment_satisfiedBronze

9:54 PM
Cambridge

Oh, I forgot to say, I tried turning the amplifier down and it just reduced the strength and quality...

link to this comment
chrism42's 29 posts GB flag
chrism42's: mapC's Freeview map terrainC's terrain plot wavesC's frequency data C's Freeview Detailed Coverage
Friday, 29 April 2011
Briantist
sentiment_very_satisfiedOwner

6:31 AM

chrism42: Don't turn the amplifier down, remove it from your system.

link to this comment
Briantist's 38,915 posts GB flag
Saturday, 30 April 2011
C
chrism42
sentiment_satisfiedBronze

8:56 AM
Cambridge

Briantist: Yes, I'd forgotten to try that. But it didn't work; made things worse, as did an attenutator. At all times, though, PSB1 was consistently weaker and suffering higher bit errors than PSB2. That was the bit I thought was interesting.

link to this comment
chrism42's 29 posts GB flag
chrism42's: mapC's Freeview map terrainC's terrain plot wavesC's frequency data C's Freeview Detailed Coverage
Wednesday, 4 May 2011
Briantist
sentiment_very_satisfiedOwner

8:12 AM

chrism42: In that case I would suggest you move the aerial to the roof from the loft.

link to this comment
Briantist's 38,915 posts GB flag
Select more comments
Page 4

Your comment please
Please post a question, answer or commentUK Free TV is here to help people. If you are rude or disrespectful all of your posts will be deleted and you will be banned.







Privacy policy: UK Free Privacy policy.