All posts by Chris.SE
Below are all of Chris.SE's postings, with the most recent are at the bottom of the page.
Briantist:
Hi Brian, I think I've found a bug :)
The last bit of my post has disappeared - it's gone into where my location would be (location not previously or intended to be entered at this time).
The tail end of my post on Tuesday 27 September 2011 10:25PM also disappeared or should I say didn't appear initially, but then appeared later, at some point after a subsequent post. Hmmm.
| link to this comment |
There we are, it's all appeared now Brian (and no longer in the location) :)
DigitaUK Trade View didn't know what to make of it!, but then that comes as no surprise, whoops, better keep my mouth shut.
| link to this comment |
Sean: replied on main Mendip board.
mr hollister:
First, try doing a Factory reset from the Setup menu and if needed do an Automatic Install, both with the aerial unplugged - This should completely clear all previous setups.
Then, plug the aerial in and do a new Install.
If that doesn't work, tell us -
Were you actually receiving from Mendip or one of the Relays? Which Multiplexes did you previously get and were they stable?
Please also give your postcode if you've still gopt a problem.
| link to this comment |
Annoyed:
Try the "Freeview reset procedure" from the link in the Yelow box below.
| link to this comment |
Jeff Glynn:
With the exception of my comment at 5.53pm about marginal areas and Arq A on C67. For clarity, it would be worth adding that this ought only to be the case if you had problems with reception of Arq B prior to Sept.28th when it was on C67 and on 26Kw.
| link to this comment |
Jack Sukerman:
One other thing 3 of us have forgotten to mention this time round - Are you using an Aerial Amplifier / Signal Booster, you could have too much signal. If you are using one, try it without. If it's a masthead one, using an attenuator may be the easiest option, but make sure it is downstream of the power source. Read Freeview signals: too much of a good thing is bad for you | ukfree.tv - independent free digital TV advice for more information about this topic.
| link to this comment |
Dave fowler:
Don't know of anything. Try some googling, possibly has Norwegian origins?
Briantist:
Hi Brian, please tell me How to name url links on here, I've got it wrong in my post above!
| link to this comment |
Rod Robert:
As Mike has suggested, you might be getting too much signalnow that SDN's power has gone to 100Kw.
Try taking your booster out of circuit to see if that makes a difference.
| link to this comment |
Thursday 29 September 2011 5:53PM
JimBilly:
C67 should not really be a problem in itself unless you are in a more marginal reception area now that the Mux (Arq A) is in 8K mode.
Jack says he's getting 10/10 signal on the other muxes, so he probably isn't marginal.
It's possible that a lot of people who were previously getting Arq A in marginal areas will not now get it until the power restriction of 26Kw goes (and move to C56) which happens in March 2012. Why they couldn't have left it in 2K mode until then, I don't know! - (they probably want to shove in some more LCN's on the mux!).