menuMENU    UK Free TV logo Help!



Click to see updates

My Sky box has a "no signal message" - what do I do?

My Sky box has a "no signal message" - what do I do?

My Sky box has a  no signal message  - what do I do?
published on UK Free TV

If you are getting the message "no signal" this would indicate that there is a problem with the signal from your dish into your box. Even without a card inserted into a Sky Digibox, if there is a signal, you will always get Sky Guide and the free channels.

Try powering off your box, remove the card, check carefully the cables, especially the connection to the dish, reapply the power and then when asked to insert your card you should then be able to see (for example) Sky News on 501 and the BBC News channel on 503.

Once you can see any channel, reinsert your card. This should, after about one minute, give you the channels you expect, such as 103, 104 and 105.

There are three ways you can attempt to reset your box. Please see What can my do when my Sky Digibox says 'No Signal' ?.

If you continue to get "No signal", you dish may have been misaligned, or there may be a fault with the cables and connectors, or a problem with the Digibox. You can see the signal strength by pressing SERVICES, then 4-SYSTEM SETUP and 6-SIGNAL STRENGTH.

All questions
BBC Three Linear channel re-opens1
Removing all barriers to communication between diverse cultures2
How do I get a test card with Freeview3
What can I do when my Sky Digibox says 'No Signal' or 'Technical fau4
Can I receive UK TV in Ghana?5
In this section
Can I use my ex-contract sky digital satellite receiver to get Freeview channels1
What can I do when my Sky Digibox says 'No Signal' or 'Technical fau2
Can I stop paying Sky and use my satellite receiver to get Freeview ?3
I have a Panasonic TV with integrated Freeview how can I record Freeview channel4
How do I change the RF output channel on a Sky Digibox?5
I have split the signal from my satellite dish and now nothing works.6

Saturday, 18 August 2018
7:35 PM

Skybox input one shows no signal strength. Or quality whereas input 2 has both good
I swapped the cables and situation changed (I expected the input strengths to reverse!)
What is happening? I can receive and record all Shy+ HD Channels but have lost BBC ITV etc

link to this comment
Alan's 2 posts ES flag
7:37 PM

Sorry on above meant to sat situation remained the same - lnb2 good, lab 1 no signal!

link to this comment
Alan's 2 posts ES flag
Sunday, 19 August 2018

10:26 AM


What you describe suggests that either one element of your LNB has failed or there is a fault in the cable connecting to the non-working input. As one works if your swap the cables then it shows your box is OK.

So carefully check all the connections in the 'F' connector that is not working correctly. Note that there must be no fine wires crossing between the inner and outer conductors and that the connector must be fully and firmly screwed on to the end of the cable with the inner core protruding enough to make contact within the socket.

link to this comment
MikeP's 3,056 posts GB flag
Friday, 6 December 2019
4:53 AM

What's up all, here every person is sharing these kinds of experience, so it's
pleasant to read this website, and I used to go to see this web site daily.

link to this comment's 1 post GR flag
Select more comments

Your comment please
Please post a question, answer or commentUK Free TV is here to help people. If you are rude or disrespectful all of your posts will be deleted and you will be banned.

Privacy policy: UK Free Privacy policy.