By providing a full postcode (such as W1A 1AA), national grid reference (for example SE123456) or latitude, longitude pair (like 54, -0.5) this page will provide a map, terrain plot and detailed information of the location showing the UK and RoI television transmitters that it is possible you receive Freeview, Freeview HD, Youview, BT TV and Saorview from.
(Don't know your postcode? Find it at Post Office Postcode finder).
UK Free TV uniquely shows you transmitter coverage maps, aerial to transmitter terrain plots, the closest 10 mobile phone masts (for possible 5G-at-800 interference) as well as tabulated information (sorted by direction, by received signal strength, by frequency, by service names or by transmitter name).
Your privacy is important
We do not pass information onto third parties and will not contact you by email. Please see our UK Free Privacy policy.
See sample prediction pages
Click on these links to see how this page looks with these sample postcodes: G40DP, BS494EG, RH164PS, KT139RP, EH526AY, TN57DT, HU151JT, CM187PN, CV212RA, EN75LG.
Please note
These predictions are based upon a rooftop aerial and depend on the suitability of the aerial, the distance to the transmitters, the power of their signals, the postcode area, and local terrain.Wednesday, 4 January 2017
MikeP
4:17 PM
4:17 PM
Stef Neumann:
Patience is the best cure! Many areas of the UK have been subject to high pressure which tends to cause TV signals to travel further than intended so causing interference. Many have reported such and waited patiently without retuning - and their programmes returned. So wait a while and DO NOT RETUNE. All that would achieve would be thwe loss of some programmes.
| link to this comment |
MikeP
4:22 PM
4:22 PM
Ricky:
You are some 20 km from the Rosemarkie transmitter and there are no hills shown as being between your location and the transmitter. Therefore it is likely that a good aerial in the loft should work for you. I use a log36 type in my loft and I am some 30 km from our 'local' transmitter. That works perfectly for us so I'd expect you would get similarly good results as long as it is correctly fitted. You would probably not need any aerial amplifier either.
| link to this comment |
Saturday, 7 January 2017
S
Sue9:35 PM
Burnley
BBC channels keep pixelating. Aerial is in loft. Any suggestions?
| link to this comment |
Sue's: mapS's Freeview map terrainS's terrain plot wavesS's frequency data S's Freeview Detailed Coverage
Wednesday, 11 January 2017
S
Stef Neumann1:44 PM
Mike P.
Thank you for your speedy reply. Sorry I missed it initially, the "Email me Updates" setting appears inoperative.
I've managed to fix the issues after some research (via Google) about "Signal vs Quality". Turns out that our Signal is pretty much steady but Quality varies unpredictably. Given that it is predominantly Quality that counts (the receiver's ability to 'read' the encoded data stream from within a given signal), I viewed the booster/splitter amp in loft with renewed suspicion. If that rather antiquated beastie is introducing more noise than expected, the quality would be poor. I secured a replacement device, which also included a 4G filter as a bonus. Installation meant switching the cable-ends to F-plugs. As none of the Midhurst channels fall into the 800MHz range, I figure the 4G filter isn't (yet) needed, so I guess the old amp had just failed in some way.
In any case, after a re-tune, the Humax now reports Quality readings at 100% for all channels.
Thanks again for taking time to reply.
| link to this comment |
MikeP
4:36 PM
4:36 PM
Stef Neumann:
Glad that sanity has returned to your household.
When dealing with signal reception problems both the strength and quality are important. Too much signal strength is as bad as not enough, or sometimes worse. Quality will always vary but the critical issue is whether it falls below a required level so that the 'decoder' can sort out what all the digits mean.
'F' connectors are becoming the preferred method of connection aerial leads. They are reliable if fitted correctly.
The frequency range used by 4G is in the bands 800 MHz, 1800 MHz (1.8 GHz) and 2600 MHz (2.6 GHz). So any transmission that is close to those frequencies could be affected by interference. In your case PSB3 on ch58 and COM5 on ch59 could be affected, so a filter may be beneficial if the 4G transmitters are close by.
| link to this comment |
M
MikeB4:46 PM
MikeP: My (split leads) were put together by a rigger using F fittings, simply because they are less likely to come apart and are a more reliable signal.
BTW - have you noticed just how many people are reporting problems that sound exactly like problems with their aerial system such as loose connections, cables, etc - and yet the transmitters are always to blame!
| link to this comment |
Thursday, 12 January 2017
MikeP
4:22 PM
4:22 PM
MikeB:
Yes, I'd noticed that too. Just responded to one such for Malvern and another for Rowridge.
| link to this comment |
P
Peter8:04 PM
All BBC has gone TV and radio and has been this way since 18:30. I use an outdoor aerial which gives me !0 as signal quality on all the commercial channels. No transmitter news on the freeview page for Tunbridge Wells.
| link to this comment |
M
MikeB9:42 PM
Peter: The transmitter has no reported faults. So logically, the fault lies with you - check your aerial system.
| link to this comment |
M
MRS .L Rolea10:43 PM
Uxbridge
Since yesterday we don't have tv signal, can you pleas sent a technician to correct the problem please asap .30 Sanctuary Close, Harefield -Middlesex poscode UB9 6LJ.Thank you
| link to this comment |
MRS's: mapM's Freeview map terrainM's terrain plot wavesM's frequency data M's Freeview Detailed Coverage
Select more comments
Your comment please