menuMENU    UK Free TV logo Freeview



Click to see updates

Freeview reception has changed?

Why should my Freeview reception change when I have not changed anything?

Why should my Freeview reception change when I have not changed
published on UK Free TV

From time to time people find that their Freeview box, integrated set (idTV) or Personal Video Recorder (PVR) has lost many channels without any apparent changes.

There are a number of factors to consider

Freeview is broadcast on digital multiplexes. This means that, once broken down into a stream of bits, each television channel is combined into a single transmission of 1s and 0s. This means that reception is of the multiplex first if this is lost it affects all the channels in the multiplex in the same way.

The signal strength received by the box or TV for a particular multiplex from a given transmitter determines if the data can be received or not. So, a poor signal results in no data, an adequate signal in perfect data and a low signal in either none or all.

Poor digital signal levels do not result, as they do with old-fashioned analogue television, in a sub-standard picture or sound. Poor signals often result in a perfect data-stream, but are prone to periods of no reception. Sometimes this will be for hours, but can also be several times a minute when caused by induction from fridges, freezers, central heating systems, two-stroke scooters, baby monitors and so on.

If you have lost ALL your Freeview channels

First disconnect the aerial lead from the Freeview box or TV set and reconnect it and then follow this reset procedure to scan for channels again. If this does not result in services being restored, check the Freeview transmitters page to see if there are any engineering problems with your local transmitter.

How to check all cables, connectors and aerials

The RF connectors need to be in very good condition to work. There are two general types:

Factory-fitted connectors are very reliable as they cannot easily be taken apart, but they can be damaged by wear and tear. On the female-type the central section is often composed of two parts which can often be forced apart, resulting in a poor connection you can push them back together if this has happened with a pair of tweezers. On male connectors if the central pin is damaged, you will need a new cable. If there are any loose partials in the connector, remove them.

Another problem with these cables is that quite easy to sprain the connector at the back which causes little obvious external damage, but disconnects the internal connection. This happens often when a set-top box is pushed backwards into a cabinet.

Hand made cables can also suffer from similar problems to factory made ones and they are also prone to accidental damage from a cable being pulled. If such a connector is not firmly attached to the cable, the connector may need refitting.


Make a visual check of the cables. There are a few basic checks:

If the cable has been slashed or cut, it will not be very effective or reliable. If such a cable is fitted externally, this can allow rainwater to enter the cable and this will reduce the signal levels.

You can easily damage an RF cable by crushing it, for example in a door. If the outside of the cable has a permanent kink in the cable or has been very tightly looped, this could be the site of damage.


For reliable and effective Freeview reception, a rooftop aerial is required. It is hard to make a visual check of such an aerial without putting yourself in potential danger.

You can make a visual check of the route between the aerial and the transmitter. Any form of obstruction will damage the digital signals. In particular trees coming into leaf, as these will leech the signal before it reaches your aerial. This applies to both trees adjacent to the aerial and at a distance.

Another common problem in cities is building work. A large crane will often change position many times during the day, and if this is between your aerial and the transmitter this can reduce the signal levels in an unpredictable way.

If your system uses a booster, the power may have failed. Check the fuse to the power to the booster.

Weather problems

There are two main weather problems that effect Freeview reception.

The Inversion Effect: please see What is the Inversion Effect and why does it effect my Freeview TV reception?

Wind: high winds sometime can dislodge the aerial this results in a poor signal.

Rain: poor or old cables can fill with water and this results in a poor signal. If this happens, the cables will require replacement.

Help with Freeview, aerials?
How do I get a test card with Freeview1
I would like to know if it is possible to receive UK terrestrial Freeview servic2
I have been told I would receive too much singal from my Freeview tansmitter as 3
Can my Freeview box receive more than one BBC and ITV region?4
Is it true that my 87 year old mother is entitled to a FREE upgrade when the ana5
In this section
Official aerial installers guide to the TV spectrum future1
Which free digital TV system will give me the most reliable reception?2
High pressure causing channel loss through "Inversion"3
Digital Region Overlap4
Two frequency interference 5
Single frequency interference6

Wednesday, 3 August 2016
6:30 PM

MikeB: I cannot get Talking Pictures on freeview 81. Any ideas?
Neil Matthews BS20 8JG

link to this comment
neil's 1 post GB flag
neil's: mapN's Freeview map terrainN's terrain plot wavesN's frequency data N's Freeview Detailed Coverage

11:04 PM

neil: If your using Mendip, then it has Com7, so you should be getting Talking Pictures, BBC4 HD, C4 + 1, etc. Unless you havn't got an HD tuner, in which case, your going to get zip. If you do have an HD tuner, then check signal strength - you might have a problem with your system, and since that mux is 25% less powerful than the rest, it might have vanished first.

link to this comment
MikeB's 2,579 posts GB flag
Thursday, 4 August 2016
David Rigby
4:32 PM

The freeview reception here in Dorset (Postcode area DT10) has deteriorated considerably in the last few weeks. Has the Txmitter power been reduced or have other factor(s) appeared which would cause this?

link to this comment
David Rigby's 1 post GB flag

4:55 PM

David Rigby: Transmit power has never been reduced on any UK transmitters since digital switchover, except temporarily when necessary for engineering work. You probably have a loose or damaged cable or joint somewhere, or perhaps water has gotten into your aerial system. Start from behind the TV and follow the aerial cable back as far as you are able to safely access. Swap out any jumper leads for a new or known working one. Unscrew any wall plates and check that the cable is securely connected at the back with no loose strands from the outer braid touching the inner connector.

link to this comment
StevensOnln1's 3,569 posts GB flag
Wednesday, 24 August 2016
John H
12:42 PM

BBC4 HD and several other channels are on Rowridges two lowest-powered multiplexes - namely 10,000 and 24,400 watts. As I only have an indoor aerial I can't receive any of the channels on the two muxes.
Strange, though, that during the Olympics BBC4 HD returned - with no problems. Now that the Games are over the HD channel has disappeared.
Is there any way for me to appeal to the 'powers-that-be' that run Rowridge to increase the power to these two muxes?
All other channels, on the 200,000 watt muxes, are fine. Installing an external aerial isn't an option for me.

link to this comment
John H's 14 posts GB flag

12:54 PM

John H: You're referring to the COM7 and COM8 multiplexes which are temporary services and are broadcast at lower power than the permanent multiplexes at nearly all of the 30 transmitters that carry them. They won't receive a power increase as this would cause interference with other transmitters broadcasting on the same frequencies and will be closing in 2020. BBC4 HD was moved to PSB3 temporarily to increase it's coverage during the Olympics but was moved back to it's normal home on COM7 yesterday.

link to this comment
StevensOnln1's 3,569 posts GB flag
John H
3:33 PM

Hi StevensOnln1,
From what you're saying I can't receive COM7 or COM8 via my internal aerial. If these are due to close in 202 what will become of the stations they carry?
Obviously, I may have seriously look into an getting external aerial - and that's going to be difficult.
If I wasn't surrounded by trees I'd ditch Freeview in favour of Freesat :-(

link to this comment
John H's 14 posts GB flag

4:03 PM

John H: By 2020 all the permanent multiplexes will have switched to DVB-T2 transmission mode (currently used by PSB3, COM7 & COM8) which will create plenty of additional capacity for the channels currently on COM7 and COM8 to move to. I would suggest you check your reception prediction via the link below (check the box for detailed view) before going to the expense of having a new aerial installed to check that you have a good chance of receiving COM7 and COM8 at your location.

Digital UK - Coverage checker

link to this comment
StevensOnln1's 3,569 posts GB flag
Thursday, 25 August 2016
John H
1:02 PM

Hi again StevensOnln1,
Thank you for your help so far. In the web page that you directed me to the channels in question require "Freeview HD equipment". My television is about a year old and is HD. Do you know of any other equipment available that would allow me to receive the channels on COM7 and COM8?

link to this comment
John H's 14 posts GB flag
1:37 PM

John H:

Further to that said by StevensOnln1, you will need a television or set top box that is not just 'HD Ready' but one fully equipped with an HD tuner to the DVB-T2 specification. Most recent TV sets that are fully equipped will be able to receive these transmissions. Find the make and model number and search on-line for the User Manual if you don't still have the one supplied. That will tell you whether it is a full HD set or just an HD Ready one which does not have a DVB-T2 tuner.

Whether you can receive them depends entirely on your location in relation to the appropriately equipped transmitters and whether there are any terrain problems making direct reception troublesome. The link provided earlier should show which transmitters you are likely to be able to receive, which services they provide and the direction an aerial should be aimed to receive their signals.

link to this comment
MikeP's 2 posts GB flag
Select more comments

Your comment please
Please post a question, answer or commentUK Free TV is here to help people. If you are rude or disrespectful all of your posts will be deleted and you will be banned.

Privacy policy: UK Free Privacy policy.