By providing a full postcode (such as W1A 1AA), national grid reference (for example SE123456) or latitude, longitude pair (like 54, -0.5) this page will provide a map, terrain plot and detailed information of the location showing the UK and RoI television transmitters that it is possible you receive Freeview, Freeview HD, Youview, BT TV and Saorview from.
(Don't know your postcode? Find it at Post Office Postcode finder).
UK Free TV uniquely shows you transmitter coverage maps, aerial to transmitter terrain plots, the closest 10 mobile phone masts (for possible 5G-at-800 interference) as well as tabulated information (sorted by direction, by received signal strength, by frequency, by service names or by transmitter name).
Your privacy is important
We do not pass information onto third parties and will not contact you by email. Please see our UK Free Privacy policy.
See sample prediction pages
Click on these links to see how this page looks with these sample postcodes: NG237JH, ST28BZ, RH28DA, TN39AH, DH70QL, DY115TQ, PA168SB, E111JF, TA245XA, BA20SJ.
Please note
These predictions are based upon a rooftop aerial and depend on the suitability of the aerial, the distance to the transmitters, the power of their signals, the postcode area, and local terrain.Wednesday, 13 November 2019
C
Chris.SE8:49 PM
gary mckenzie:
What time did you retune? The HD mux may still have been off-air at the time. Try again, but first of all, unplug the aerial and do a full retune which should clear all existing tuning. Then plug it back in and retune again, hopefully this will restore all channels. If you are still having problems, post back with a full postcode.
I assume you are getting your signal from Pontop Pike.
| link to this comment |
Tuesday, 19 November 2019
I have noticed whilst staying in the area of Minehead on the north Somerset coast that the freeview signal meant for South Wales is received instead of for the south western region of England. Can nothing be done to block the signal coming from South Wales in this area?
| link to this comment |
Can anything be done to stop the freeview signals from Wales being received on the north Somerset coast in the region of Minehead instead of the services for south western England?
| link to this comment |
C
Chris.SE5:11 PM
Nicholas Anderson:
First point is in answer to your question - No! The radiation pattern of any transmitter is generally done to provide coverage to a particular area. That means that sometimes you can pick up the signal outside the intended area because with the transmitter location and the area it has to serve, it means the signal goes in that direction.
If you want a West Country transmitter, you need to point your aerial in the direction of that transmitter and not a South Wales. If both happen to be in the same direction from your particular location then it's best to do a manual tune to the UHF channels used by the wanted transmitter's multiplexes.
There is one exception that I know of however, and that's in the Carhampton area, where the channels that Kilvey Hill in South Wales were moved to back in the summer, are the same channels as Carhampton. Kilvey Hill is readily receivable on parts of the North Devon Coast. This appears to be a major blunder by DigitalUK, Arqiva and OFCOM!
Second point, I've noticed that several of your posts are appearing twice. When you make a post here, it does not appear immediately, you need to wait a short while. Please don't repeat post because you don't see your post immediately.
| link to this comment |
Sunday, 24 November 2019
Morning Chris
Our aerial is on the roof/chimneystack.
I've re-turned our 8yearold Ferguson on 'Autotune at least ten times (although not this morning - 24/11/19)channel 4, ITV, and channel5 are all almost completely intermittent/breaking up
I'm going downstairs to have another retune/autotune go and will let you know if everything puts itself right (???)
Tom Richardson
TS5 6EE
| link to this comment |
Tom's: mapT's Freeview map terrainT's terrain plot wavesT's frequency data T's Freeview Detailed Coverage
C
Chris.SE3:44 PM
Tom Richardson:
It might depend on when you previously retuned, and which transmitter you are actually receiving/wanting to receive. There has been Planned Engineering at Pontop Pike and Bilsdale this last week with "Possible service interruptions". You are predicted to get good reception from both of those.
There is also a low power relay closer to you (with variable/poor reception) which you may have got inadvertently tuned to if you retuned when your chosen transmitter was off-air. It's not a good idea to retune when a transmitter is off-air, you just lose all your correctly tuned channels!
I suggest you try the following first - unplug the aerial and do an automatic tune. This should clear all previous tuning as no channels will be found. Then plug the aerial back in and repeat the automatic retune which will hopefully restore all multiplexes correctly. (2 -PSBs, 3COMs and a Local if your set doesn't have an HD tuner).
If you are receiving Bilsdale (best choice & closer) your aerial should be pointing ~SSE (163 degrees) with the rods horizontal.
If you are receiving Pontop Pike your aerial will be pointing ~NE (315 degrees) with the rods horizontal.
If your set has the option the see which UHF channels it has tuned to for each multiplex or indeed allow a manual tune if autotune doesn't resolve the problem, the channels are as follows in the order PSB1&2, COMs4-6, Local, for the SD channels, + if you have HD PSB3, COMs 7 & 8 -
Bilsdale - 21, 24, 43, 46, 40, 30 + 27, 55, 56, you may struggle with reception of the COMs (SD &/or HD) if you have an old Group A aerial.
Pontop Pike - 39, 42, 32, 34, 35, 33 + 44, 55, 56, you may struggle with reception of the COMs (SD &/or HD) if you have an old Group B aerial.
Note, you only may struggle with reception of some multiplexes with old aerials, a lot depends on location and distance to the transmitter. Ideally you need a Group T/Wideband to get all multiplexes reliably.
| link to this comment |
Thursday, 5 December 2019
M
Mr A.Squires5:55 PM
Bracknell
I had an ariel put in the roof because I wanted to receive Meridian news (previously could only get London news)
However,there are some channels that keep stating 'low signal' even when the weather is not too bad,so I view through my Humax box which is better but then all I get is the picture stop for a second or so and I lose a few words of dialogue.I also thought that at my address RG12 2QJ I received from the Hannington transmitter but when I went into your website and put this info in it stated I was geared to the Crystal Palace transmitter,but I could not find any reference to my area at all - can you please explain
| link to this comment |
Mr's: mapM's Freeview map terrainM's terrain plot wavesM's frequency data M's Freeview Detailed Coverage
Friday, 6 December 2019
C
Chris.SE7:23 AM
Mr A.Squires:
Sometimes predicted reception can be quite variable when you live in an area that has overlapping coverage from more than one transmitter particularly if you are on the periphery of these areas. It looks as though you could have line of sight to several transmitters depending on your precise location within your postcode. It can be especially tricky if the location has local obstructions or is a bit hilly which could be the case with you.
The official Freeview Detailed Coverage Checker does show such variations across your postcode, but mainly good reception from most of the main 6 multiplexes and also the COMs 7&8 multiplexes depending on your precise location. Similar results are obtained from the BBC's RTIS predictions. Both show good or variable reception results from Hannington and Crystal Palace and again they change with precise location.
This means that good aerial location will be very important as will the choice of aerial needing sufficient gain and appropriate beamwidth/polar response. Local weather conditions can also have significant effects on loft mounted aerials, as can the presence of water tanks, walls & etc.
When more transmitters share frequency (UHF channel) usage around the country as is more the case now, changes to reception can occur in some weather situations and when transmitters might be undergoing planned maintenance or have faults. It is also important that your own installation is free of faults.
One thing you can do is check all your coax plugs, connections, flyleads etc, unplug connectors check for corrosion or other problems and reconnect them. Flyleads are a common problem, try swapping/changing them. See what signal strengths and quality you are getting for the multiplexes shown in your TV's tuning section. Also check that your downlead looks undamaged (especially if it is old) and that your aerial seems intact and pointing in the correct direction.
Problematic connections, water ingress etc. can seem to affect reception of just an individual or several multiplexes.
If you have frequent problems with specific channels check Channel listings | Freeview to see which multiplex they are on, as reception of some multiplexes can be variable in a particular location.
| link to this comment |
C
Chris.SE7:35 AM
Mr A.Squires:
I should have added that for Hannington your aerial should be pointing at a bearing of 250 degrees - that's marginally West of WSW and the rods should be horizontal. The precise direction may vary by a few degrees for best signal strength depending on aerial location.
| link to this comment |
Sunday, 15 December 2019
T
Tamsin Mc Cormick1:54 AM
Liverpool
I have a wide band aerial pointing at Storeton . It is attached to a short chimney stack .
Will I need this to be re-aligned to Winter Hill as there are a number of channels currently not available from Storeton (BBC4 HD etc ). Or will Storeton have the remaining channels added in due course ?
If I do need a re-alignment is there a free service for this ?
| link to this comment |
Tamsin's: mapT's Freeview map terrainT's terrain plot wavesT's frequency data T's Freeview Detailed Coverage
Select more comments
Your comment please