Full Freeview on the Rowridge (Isle Of Wight, England) transmitter
 | Google Streetview |  | Google map |  | Bing map |  | Google Earth |  | 50.676,-1.369 or 50°40'35"N 1°22'7"W |  | PO30 4HT |
The symbol shows the location of the Rowridge (Isle Of Wight, England) transmitter which serves 620,000 homes. The bright green areas shown where the signal from this transmitter is strong, dark green areas are poorer signals. Those parts shown in yellow may have interference on the same frequency from other masts.
This transmitter has no current reported problems
The BBC and Digital UK report there are no faults or engineering work on the Rowridge (Isle Of Wight, England) transmitter._______
Digital television services are broadcast on a multiplexes (or Mux) where many stations occupy a single broadcast frequency, as shown below.
64QAM 8K 3/4 27.1Mb/s DVB-T MPEG2
DTG-12 QSPK 8K 3/4 8.0Mb/s DVB-T MPEG2
H/V: aerial position (horizontal or vertical)
Which Freeview channels does the Rowridge transmitter broadcast?
If you have any kind of Freeview fault, follow this Freeview reset procedure first.Digital television services are broadcast on a multiplexes (or Mux) where many stations occupy a single broadcast frequency, as shown below.
64QAM 8K 3/4 27.1Mb/s DVB-T MPEG2
DTG-12 QSPK 8K 3/4 8.0Mb/s DVB-T MPEG2
H/V: aerial position (horizontal or vertical)
Which BBC and ITV regional news can I watch from the Rowridge transmitter?
BBC South Today 1.3m homes 4.9%
from Southampton SO14 7PU, 26km north (354°)
to BBC South region - 39 masts.
ITV Meridian News 0.9m homes 3.6%
from Whiteley PO15 7AD, 24km north-northeast (20°)
to ITV Meridian (South Coast) region - 39 masts.
All of lunch, weekend and 50% evening news is shared with all of Meridian plus Oxford
Are there any self-help relays?
| Portsmouth Docks | Transposer | 2 km N city centre | 50 homes Estimate. Group of houses' |
How will the Rowridge (Isle Of Wight, England) transmission frequencies change over time?
| 1950s-80s | 1984-97 | 1997-98 | 1998-2012 | 2012-13 | 2 May 2018 | ||||
| VHF | A K T | A K T | A K T | A K T | W T | ||||
| C3 | BBCtvwaves | ||||||||
| C21 | C4waves | C4waves | C4waves | +BBCB | BBCB | ||||
| C22 | +ArqA | ArqA | |||||||
| C24 | BBC2waves | BBC2waves | BBC2waves | BBCA | BBCA | ||||
| C25 | SDN | SDN | |||||||
| C27 | ITVwaves | ITVwaves | ITVwaves | D3+4 | D3+4 | ||||
| C28 | ArqB | ArqB | |||||||
| C29 | LSO | ||||||||
| C31 | BBC1waves | BBC1waves | BBC1waves | com7 | |||||
| C37 | com8 | ||||||||
| C55tv_off | com7tv_off | ||||||||
| C56tv_off | COM8tv_off |
tv_off Being removed from Freeview (for 5G use) after November 2020 / June 2022 - more
Table shows multiplexes names see this article;
green background for transmission frequencies
Notes: + and - denote 166kHz offset; aerial group are shown as A B C/D E K W T
waves denotes analogue; digital switchover was 7 Mar 12 and 21 Mar 12.
How do the old analogue and currrent digital signal levels compare?
| Analogue 1-4 | 500kW | |
| PSB1||, PSB1≡, PSB2||, PSB2≡, PSB3||, PSB3≡ | (-4dB) 200kW | |
| COM4≡, COM4||, COM5≡, COM5||, COM6≡, COM6|| | (-10dB) 50kW | |
| com7≡ | (-13.1dB) 24.4kW | |
| Mux 1*, Mux 2*, Mux A*, Mux B*, Mux C*, Mux D* | (-14dB) 20kW | |
| com8≡ | (-14.3dB) 18.4kW | |
| LSO≡ | (-17dB) 10kW |
Local transmitter maps
Rowridge Freeview Rowridge DAB Rowridge TV region BBC South Meridian (South Coast micro region)Which companies have run the Channel 3 services in the Rowridge transmitter area
|
|
Thursday, 11 July 2013
M
Mark Pyke7:26 AM
Living in Winchester always received signal from Rowridge after request for retune have lost HD signal - why?
Thanks
| link to this comment |
MARK PYKE
Have you lost HD on all equipment or just one?
Is your aerial Wideband or Group A
If it is a Wideband you should get it changed as Rowridge is a Group A transmitter, HD is transmitted on UHF 21 which is the first frequency for TV reception, although a Wideband aerial does work from settings 21-68 they actually perform better at the higher end of the spectrum, therefore it can sometimes be difficult to receive the HD reception from a Wideband aerial being used on a Group A transmitter.
| link to this comment |
Jamie's: mapJ's Freeview map terrainJ's terrain plot wavesJ's frequency data J's Freeview Detailed Coverage
R GREGORY
Freeview works differently to Freesat.
If your sat dish is aligned correctly all receptions will work.
Freeview is different in the fact that you have 6 UHF settings which your aerial is receiving the TV channels, all TV channels are split over these 6 settings, if 1 setting is working correctly then all the channels on that setting will work, if a setting is not being received correctly then you will have missing channels or pixilation on those channels.
Getting all 6 UHF settings working correctly relies on the antenna being in good condition, good condition cable and most importantly the antenna located in the correct part of the building, not always the highest point, sometimes even a few feet left or right can make a difference in receiving reception.
:)
| link to this comment |
Jamie's: mapJ's Freeview map terrainJ's terrain plot wavesJ's frequency data J's Freeview Detailed Coverage
Friday, 12 July 2013
J
jb387:52 AM
Mark Pyke: You should also be aware that engineering work is being carried out at Rowridge during the whole of this week and so the service is liable to suffer periods of interruption at any time, your retune having possibly coincided with the HD transmitters down time.
If HD is still missing you should carry out another retune.
| link to this comment |
P
Phil King12:20 PM
Poole
Well, we're not getting any Freeview channels (from Rowridge VP) working over here in Holton Heath . Is it the engineering work, hot weather, or a combination of the two? Our reception is usually pretty solid on the PSB muxes and COM6, though the others are patchy. Signal strength is fine, but quality is zero.
| link to this comment |
Phil's: mapP's Freeview map terrainP's terrain plot wavesP's frequency data P's Freeview Detailed Coverage
J
john1:55 PM
Harrow
Phil King: likely you've answered your own question, although it is more likely the transmitter work is to blame. quality is in general more important than strength unfortunately! ideally strength should be 75% quality 100%.
| link to this comment |
john's: mapJ's Freeview map terrainJ's terrain plot wavesJ's frequency data J's Freeview Detailed Coverage
Monday, 15 July 2013
P
Phil King8:04 PM
Thanks John. Looks like the engineering work has finished but our signal is still terrible, so it must be the weather causing interference.
| link to this comment |
Sunday, 21 July 2013
I
Ian Pendlebury8:44 AM
We have lost all COM4 channels from rowridge transmitter after a retune. Signal strength reports as 0 on Ch 25. Another box we have not retuned shows the channels properly. All off the same aerial. Any ideas?
| link to this comment |
IAN PENDLEBURY
There are a few reasons which could give you this issue.
1. the cable or connections to the problem receiver has an issue.
2. the receiver itself has an issue.
3. all of the system has an issue, the reason I give this issue is that all equipment reacts differently to reception, so if your signal is not very good you could have one box that can still handle showing channels with poor reception but another box not showing the channels. I commonly find Sony TV showing channels with a reception so poor that no other brand can display any channels.
regards
Jamie
Qualified Installer :)
| link to this comment |
Jamie's: mapJ's Freeview map terrainJ's terrain plot wavesJ's frequency data J's Freeview Detailed Coverage
Tuesday, 23 July 2013
P
Phil King8:09 PM
Still terrible reception here in Holton Heath. It was fine up until the week the transmitter engineering work (and heatwave) started. Could the weather still be causing this problem?
| link to this comment |
Select more comments
Your comment please