Full Freeview on the Bilsdale (North Yorkshire, England) transmitter
Google Streetview | Google map | Bing map | Google Earth | 54.358,-1.151 or 54°21'30"N 1°9'2"W | TS9 7JS |
The symbol shows the location of the Bilsdale (North Yorkshire, England) transmitter which serves 570,000 homes. The bright green areas shown where the signal from this transmitter is strong, dark green areas are poorer signals. Those parts shown in yellow may have interference on the same frequency from other masts.
Are there any planned engineering works or unexpected transmitter faults on the Bilsdale (North Yorkshire, England) mast?
_______
Digital television services are broadcast on a multiplexes (or Mux) where many stations occupy a single broadcast frequency, as shown below.
64QAM 8K 3/4 27.1Mb/s DVB-T MPEG2
H/V: aerial position (horizontal or vertical)
Which Freeview channels does the Bilsdale transmitter broadcast?
If you have any kind of Freeview fault, follow this Freeview reset procedure first.Digital television services are broadcast on a multiplexes (or Mux) where many stations occupy a single broadcast frequency, as shown below.
64QAM 8K 3/4 27.1Mb/s DVB-T MPEG2
H/V: aerial position (horizontal or vertical)
Which BBC and ITV regional news can I watch from the Bilsdale transmitter?
![regional news image](/styles/images/regionalnews/302x152/bbc-look-north-newcastle.jpg)
BBC Look North (Newcastle) 1.6m homes 6.0%
from Newcastle NE99 2NE, 74km north-northwest (336°)
to BBC North East and Cumbria region - 70 masts.
![regional news image](/styles/images/regionalnews/302x152/itv-tynetees.jpg)
ITV Tyne Tees News 1.4m homes 5.4%
from Gateshead NE11 9SZ, 75km north-northwest (333°)
to ITV Tyne Tees region - 47 masts.
All of lunch, weekend and 50% evening news is shared with Border
Are there any self-help relays?
Garsdale (pin Fold) | Transposer | 63 homes (coverage together with SH34) | |
Hawsker Bottom | Active deflector | 150 caravans | |
Langthwaite | Active deflector | 30 homes |
How will the Bilsdale (North Yorkshire, England) transmission frequencies change over time?
1984-97 | 1997-98 | 1998-2012 | 2012-13 | 13 Nov 2019 | |||||
A K T | A K T | A K T | K T | W T | |||||
C21 | BBCB | ||||||||
C23 | C4waves | C4waves | C4waves | BBCB | |||||
C24 | _local | D3+4 | |||||||
C26 | BBC2waves | BBC2waves | BBC2waves | BBCA | |||||
C27 | BBCA | ||||||||
C29 | ITVwaves | ITVwaves | ITVwaves | D3+4 | |||||
C30 | _local | ||||||||
C31 | com7 | ||||||||
C33 | BBC1waves | BBC1waves | BBC1waves | ||||||
C35 | C5waves | C5waves | |||||||
C37 | com8 | ||||||||
C40 | ArqB | ArqB | |||||||
C43 | SDN | SDN | |||||||
C46 | ArqA | ArqA | |||||||
C55tv_off | com7tv_off | ||||||||
C56tv_off | COM8tv_off |
tv_off Being removed from Freeview (for 5G use) after November 2020 / June 2022 - more
Table shows multiplexes names see this article;
green background for transmission frequencies
Notes: + and - denote 166kHz offset; aerial group are shown as A B C/D E K W T
waves denotes analogue; digital switchover was 12 Sep 12 and 26 Sep 12.
How do the old analogue and currrent digital signal levels compare?
Analogue 1-5 | 500kW | |
BBCA, D3+4, BBCB | (-7dB) 100kW | |
SDN, ARQA, ARQB | (-10dB) 50kW | |
com7 | (-14.3dB) 18.5kW | |
com8 | (-14.4dB) 18.1kW | |
Mux 2*, Mux A*, Mux B*, Mux C* | (-19.2dB) 6kW | |
Mux 1* | (-20.2dB) 4.8kW | |
Mux D* | (-24.9dB) 1.6kW |
Local transmitter maps
Bilsdale Freeview Bilsdale DAB Bilsdale TV region BBC North East and Cumbria Tyne TeesWhich companies have run the Channel 3 services in the Bilsdale transmitter area
|
|
Is the transmitter output the same in all directions?
Radiation patterns withheldSunday, 19 August 2012
STEPEHN GOODALL: The BBC multiplex (Mux 1) is on lower power at 4.8kW. Mux D is even lower at 1.6kW. The rest are at 6kW.
There is probably little you can do until switchover in September.
You might be interested to know that now Olivers Mount has switched to digital, it is broadcasting at a higher power than its former analogue. If you were unable to receive it before, you "may" be able to do so now. This would obviously give you Yorkshire regional programming.
I can see on Streetview (photos taken January 2009, before Yorkshire switchover) that there are some vertically polarised aerials, although with Olivers Mount and the Hunmanby relay being in roughly the same direction, it isn't possible to sure which they are pointing at.
Hunmanby carries Public Service Broadcaster (PSB) channels only; they are BBC, ITV1, ITV2, Channel 4, E4, More 4, Channel 5, the four HD services and a few others. The other channels are the Commercial (COM) ones (ITV3, Pick TV, Yesterday, Film 4, Dave etc) and these are only carried by main transmitters, including Oliver's Mount and Bilsdale.
Oliver's Mount's PSBs' power is 2kW and its COMs are 1kW. You may be able to receive both; or, if its PSBs are only strong enough to reach your location, you could always combine (diplex) an aerial on Oliver's Mount with the Bilsdale one you have to give you the Yorkshire PSBs and COMs from Bilsdale (or PSBs from Bilsdale if you wish).
Unfortunately, if you can receive from Hunmanby, due to the UHF channels (frequencies) it and Bilsdale uses, it isn't possible to diplex two aerials in this situation. You could, of course, have two aerials and feed them into separate receivers.
link to this comment |
Stephen Goodall: Check that, for BBC services (BBC One, BBC Two etc), that it is tuned to UHF channel 34 by viewing the signal strength screen whilst on one of those channels. This is Bilsdale; Oliver's Mount is on C57 and Hunmanby is on C48.
If it turns out that it is tuned to C57 or C48, then run the automatic tuning scan through and unplug the aerial when it gets to 45% (or when it gets past UHF channel 42 if it gives these whilst scanning). This will scan channels used by Bilsdale, but miss out those of the two other stations.
Of course, it could be that Bilsdale's C34 isn't good enough to serve you, so you may find that your receiver won't pick it up.
link to this comment |
Stephen Goodall: The Digital UK Postcode Predictor is now back on and it "thinks" that you will have "good" reception from Oliver's Mount, including the COMs, albeit that COM6 is "variable" now until September, presumably because Pontop Pike is currently broadcasting analogue on the same channel, but isn't co-channel after switchover. With this in mind, it may well be OK now.
One thing I've just noticed, which I didn't pick up on before, is that Mux D from Bilsdale (Yesterday, Film 4 etc) is on C42, which is co-channel with one of Hunmanby's. It is also the one on the lowest power, so you "may" find that it is non-existant, or intermittent. I guess that the lower power is due to it being broadcast on a channel (frequency) that is re-used elsewhere in (relatively) close proximity, such as is the case here. Therefore, it's to protect, or reduce the possibility of interference being caused to those watching the output of the other (co-channel) transmitter(s).
link to this comment |
Monday, 20 August 2012
E
egh9:21 PM
Bilsdale transmitter. One problem for people living in parts of Cleveland is the ridge of the Eston Hills. The terrain map suggests that there should be line of sight transmission to Bilsdale whereas, in fact, I have a high ridge of ground directly in the way and we have always had better reception from Pontop Pike.
When Bilsdale first started transmitting we switched to the new transmitter but experienced severe ghosting due to structures on the Wilton Site and changed back. Friends living close by still viewing Bilsdale are still reporting problems although my wife, who acts as my detector, has said we are rarely experiencing them and, hopefully, when the radiated power is increased they will vanish
link to this comment |
Saturday, 25 August 2012
J
john B11:24 AM
I have a Sharpe HD tv with built in Freeview. I live in TS70PS and the HD Freeview will be on next month Sept2012. Will I need a new HD FREEVIEW Box or will my HD TV adjust to the the better resoloution automatically?
link to this comment |
john B: If you post the model number then we can check on the specifications.
Some TVs, often branded with the "HD Ready" logo, can show HD pictures, but do not have the ability to receive Freeview HD signals. They only have a tuner capable of receiving DVB-T signals, which is the format of standard definition broadcasts. They therefore require a separate box if they are to show broadcast HD pictures.
Freeview HD signals are broadcast using the DVB-T2 format, and hence TVs with tuners that can receive DVB-T2 (as well as DVB-T) can pick-up the Freeview HD signals without the need for a separate box.
link to this comment |
Monday, 27 August 2012
J
jim 4:37 PM
i live in middlesbrough town centre and for the past few days i've been having trouble with channels 3, 4, 5 and a few others. usually if these channels are down, most of the others are as well. but this time it's not the case. is anyone else experiencing similar problems?.. on a side not, i haven't been able to get bbc channels for a long time, with the exception of bbc 4
link to this comment |
Thursday, 30 August 2012
D
Dorothy9:30 AM
Like Jim I have experienced a complete loss of Channels 3 4 and 5 even after retuning (3 times). The loss is only on my 2 digital TVs (Toshiba and Samsung) and not on any of my 4 digital boxes.
link to this comment |
Friday, 31 August 2012
K
Kevin2:17 PM
I live in Stocckton on Tees TS19 and I was watching BBC HD Paralympic opening ceremony along with other programmes in HD on my new SONY HD TV (Which means I have the facility to receive and show HD programmes)
After e programme retune all HD Channels had gone this was done yesterday 30th August
What happened to them please?
Are they reappearing?
link to this comment |
Robert Hill
8:52 PM
8:52 PM
Kevin. juat a question? Where do you receive television from? Bilsdale Transmitter or the Pontop Pike? If its Bilsdale, you will not be receiving HD yet,not till the 26th September (DSO 2). Now if it is from Pontop Pike that is transmitting HD.
By the way the Paralympics are Channel 4.
link to this comment |
Select more comments
Your comment please